User Manual
26
Note: If you’re using modeling light modes F3-2 or F3-3, the modeling light power
is set proportionally as you increase or decrease the ash power output.
6. Set the exposure settings you want to use on your camera (check your
camera’s manual for specic instructions).
7. Take a test exposure, and make the necessary changes to the camera or
monolight.
Tip: For best results, a handheld ash meter is recommended when using the
manual ash mode.
Using the Venture TTL 600 as a Manual Flash in P.Cell (Slave)
Mode
One or all of your Venture TTL 600 monolights can be used as optical slaves. To
set the monolight to re when it senses the ash from another ash unit, follow
these steps:
1. Adjust the ash and modeling light power (pages 24)
2. Press the P.CELL button. The optical sensor will glow green to indicate that
it's been activated.
Operating the Venture TTL 600 (continued)