User Manual
18
Restoring Factory Presets
To restore the factory presets of the Venture TTL 600, press and hold the P.CELL
button while powering on the monolight.
Note: Manual mode or TTL mode settings that were previously set will not be
saved when performing this operation.
Selecting the Personal ID Number
If you are using the Venture wireless transmitter, the personal ID number on the
monolight must match the personal ID number on the wireless transmitter.
1. Turn the power on while pressing and holding the CH/ID button. The
personal ID number will appear on the LCD screen.
2. Rotate the COMMAND dial to change the personal ID number.
3. Press the COMMAND button to set the personal ID number and continue to
the main screen.
Selecting Channels and Groups
1. Press the CH/ID button repeatedly to select channels 1–9.
2. Press and hold the CH/ID button while rotating the COMMAND dial to select
group A, B, or C.
Tip: When using multiple lights, label each light with its group and channel
number as visual reminders.
Note: Channel and group settings from the previous session are stored in the
Venture’s memory. When powering up the Venture TTL 600, it will be set to the
channel and group that were previously selected.
Conguring the Settings