User Manual

Quick-Start Guide

Turning the power on: Move the power switch to the On position.

Set the personal ID number: Press and hold the CH/ID button while powering

on the unit. Rotate the COMMAND dial to choose the ID number. Press the

COMMAND dial to set the selection and continue to the main screen.

Restore factory default settings: Press and hold the P.CELL button while

powering the unit on.

Flash operating mode menu: Press and hold the SOUND/FN button until F3

or F4 appears on the LCD screen. Rotate the COMMAND dial to F4. Press

the COMMAND dial to choose modes F4-1 (Quick) or F4-2 (Power). Press the

SOUND/FN to conrm your selection. When F4-2 (Power) is selected, the LED

indicator will glow blue.

Turning on the modeling light: Press the MODEL button.

Modeling light mode menu: Press and hold the SOUND/FN button until F3 or

F4 appears on the LCD screen. Rotate the COMMAND dial to F3. Press the

COMMAND dial to choose modes F3-0 to 3. Press the SOUND/FN button to

conrm your selection.

Adjusting the modeling light brightness (F3-0 or F3-1 only): Press and hold the

MODEL button while rotating the COMMAND dial.

Selecting groups: Press and hold the CH/ID button and rotate the COMMAND dial.

Selecting channels: Press the CH/ID button.

Selecting optical mode: Press the P.CELL button. The optical sensor will glow green.

Adjusting the ash output power: Rotate the COMMAND dial. The power can be

adjusted in 1/3-stop increments.