User's Manual
6
Mounting an Umbrella
The monolight’s handle is equipped with an umbrella mount.
To mount an umbrella, t the umbrella shaft through the
umbrella hole, and tighten the locking knob.
To use the umbrella with a reector, rst attach the
reector to the monolight. Then t the umbrella shaft
through the reector’s umbrella hole before you insert it
through the handle’s umbrella hole.
Note: To avoid damaging the umbrella’s shaft, do not overtighten the umbrella
locking knob.
Powering the Monolight
Plug the power cord into the back of the monolight. Before plugging it into a
power outlet, make sure the power switch is in the off position.
To activate the ash without the modeling light, set the power switch to the top
position.
To activate the ash and turn on the modeling light, set the power switch to the
bottom position.