User Manual

www.impactstudiolighting.com
PT-100
Posing Table
ASSEMBLY INSTRUCTIONS
Parts List
1 – Tabletop
1 – 5/16” × 1” hex-head screw
2 – 1/8” × 1” screws
1 – Mounting bracket
4 – 1/4” × 1/2” screws
1 – Main column and riser
1 – Locking knob
1 – Pedestal base
5 – Casters
1 – Hex key
1 – Anti-twist Washer
Tabletop
Mounting
bracket
3/8” hex-head
screw and
two 1/8” × 1”
screws
Four screws,
1/4” × 1/2”
Main
column
Locking
knob
Riser
Anti-twist
washer
Pedestal
base
Locking
casters (5)
Step One
Remove all the parts from the carton, and make
certain you have all the items in the parts list
above and in the correct quantity.
Step Two
Remove the mounting plate from the tabletop with
a Phillips screwdriver.
Step Three
Push the cylinder all the way down onto the
pedestal base until it's secure.
Step Four
Place the anti-twist washer on the cylinder, and
align the holes with the screw sockets in the
cylinder. Place the mounting bracket over the
washer, and align the holes. Use a Phillips
screwdriver and the included hex key to securely
tighten the 5/16” hex-head screw and the two
1/8” × 1” screws.
Step Five
Use the four 1/4” × 1/2” screws to attach the
tabletop to the mounting bracket with a Phillips
screwdriver.
Make certain all screws are tightened fully before
using this posing table.
Step Six
Adjust the tabletop to your desired height, and
tighten the locking knob.