User Manual
23
Troubleshooting
• Make sure that all devices are set to the same channel.
• If your rst choice of channel doesn’t work due to interference, try
different channels until you nd one that works.
• Make sure that all cables are installed correctly.
• Make sure that the power source for each device is properly installed
and carrying a sufcient charge. Weak batteries can reduce the
distance over which a transmission works.
• Make sure the devices are connected using the correct cable and
make sure the cable is connected to the correct input/output port.
• Make sure that the communication conrmation light appears when
sending or receiving a signal.
• Verify that ash and camera equipment are operating properly.
• Make sure the devices are within the maximum operating range.
• Verify that your camera and ash are compatible with this device.
Please reference the Device Compatibility section of this manual (pg.
10) for more information.
FCC DISCLAIMER:
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Made in China