User Manual

Using as a Camera Trigger

Triggering Your Camera

Connecting the receiver to the camera

1. Turn off all devices.

2. Slide the receiver’s cold-shoe foot into the camera’s hot shoe.

3. Tighten the locking ring to secure the devices.

4. Connect the devices with the appropriate shutter release cable (not

included). Insert the 2.5 mm sync cable into the receiver’s output, and

the other end into the camera’s shutter release port.

5. Synchronize the channels on the transmitter and receiver.

6. Turn on the transmitter, receiver, and camera.

7. Set the camera to single-shot mode.

8. Half-press the Test/Shutter Release button on the transmitter to auto-

focus the camera. The camera and lens must be set to auto-focus for

this function to work.

9. Press the Test/Shutter Release button on the transmitter to trigger the

camera’s shutter.

NOTE: See insert for compatible Shutter Release Cables.