User Manual

Wirelessly Triggering Your Hot-Shoe Flash

1. With the device turned off, connect the transmitter to

the camera (see setup instructions in “Connecting the

Transmitter to the Camera” on pg. 13).

2. With the hot-shoe ash turned off, connect the ash to

the receiver. Tighten the ash’s locking lever to secure the

devices.

3. Mount the connected receiver and ash to a light stand or

secure it into the desired position.

4. Synchronize the channels on the transmitter and receiving

devicest.

5. Switch on the receiver and ash devices.

6. Press the on-camera shutter release button or the test

button on the transmitter to re the ash.

Wirelessly Triggering Your Studio Flash

1. With both devices turned off, connect and secure the

transmitter to your camera (see setup instructions in

“Connecting the Transmitter to the Camera” on pg. 13).

2. With the studio ash turned off, connect the receiver to

the studio ash (see setup instructions in “Mounting the

Receiver to a Studio Flash” on pg. 15) using the included

cable.