User Manual
12
LED Indicator Lights
The PowerSlave transmitter and receiver each contain an LED indicator light.
The lights display their device status slightly differently.
Transmitter:
• Power on: one green ash
• Auto-focus: green while trigger button half-pressed
• Trigger: red while trigger button fully pressed
Receiver:
• Power on: one red ash
• Auto-focus: green while transmitter trigger button half pressed
• Trigger: red while transmitter trigger button fully pressed
Channel Selection
The PowerSlave transmitter and receiver provide the user with 16
selectable channels. Make sure that both the transmitter and the receiver
are set to the same channel. Select a channel by conguring the four
switches as shown in the chart below.
Note: Channel 1 sends a “trigger all” signal to all available receivers,
regardless of what channel they are set to.
1
9 10 11 12 13 14 15 16
2 3 4 5 6 7 8