User Manual

10
Step 3: Setting Up the Receiver (AC Model)Step 3: Setting Up the Receiver (DC Model)
• Be sure your ash head is turned
OFF. Unplug the power cord from
the wall socket.
• Unplug the AC power cord from
the ash (either the power pack or
mono light) and plug it into the
bottom of the PowerSync AC
Receiver.
• Insert the power cord of the
receiver into the AC power socket
of the ash.
• Then insert the sync cord of the
receiver into the sync socket of
the ash. Once the ash power is
turned ON, the PowerSync AC
Receiver will be turned on
automatically.
The AC version of the PowerSync
comes complete with 1/4˝ and 1/8˝
(phono plug or miniplug) sync
inputs. For other sync options,
see the Accessories page towards
the back of this manual.
20-page manual to be inserted into packaging for AC and DC model receivers
10
11
If using a portable ash unit, you
can attach the ash directly to the
DC Receiver’s hot shoe. With the
1/4˝ female threads on the back of
the DC Receiver, you can then
mount your remote ash on a tripod
or a light stand with an adapter.
You can also use the DC Receiver’s
sync cord to connect directly to a
studio ash. Included with your
kit is a mount that will allow
you to attach the receiver
temporarily to your ash with
an adhesive backing, or you
can use a lanyard. If you are
getting radio interference
from the ash’s electronics,
have the receiver dangle
on a lanyard, keeping the
antenna from being too
close to the ash’s
electronics. Your DC Receiver can now be turned on with
the switch on top of the unit.