User Manual

2
Assembly (continued)
Insert the other end of the tension
rod into the speedring hole on the
side of the light head.
Insert the next rod at the exact op-
posite side (180°) of the rst rod that
was inserted. Insert one end into
the correct pocket on the OctaCool
softbox rst, and then insert the
other end into the light head.
Insert the next two rods at a 90° an-
gle from the rst two rods that were
inserted. Follow the same steps as
the rst two rods. Insert one end
into a pocket on the OctaCool soft-
box rst, and then insert the other
end into the light head.
4
5
6