FRC-22/24 Ready Cool Fluorescent Light Instructions 1
Precautions ⚠⚡ • • • • • • • • • • • • • • Handle fluorescent bulbs with care. See Note below. Dispose of fluorescent bulbs properly. Please read and follow these instructions, and keep this manual in a safe place. Keep this unit away from water and all flammable gases or liquids. Make sure the unit is powered off when plugging it into a power source. Use only the correct, recommended voltage.
Introduction Thank you for choosing the Impact Ready Cool FRC-22 110w or FRC-24 220w Ready Cool Fluorescent Light. This lightweight daylight-balanced fluorescent lighting fixture is an inexpensive way to produce soft, professional lighting in the studio or on location. Fluorescent bulbs deliver diffused, flattering light. Fluorescents are also cool to the touch, so they’re ideal for photographing anything that’s affected by heat, like food or people.
Introduction Features Contents Include • • • • • • • • • Cool-running daylightbalanced fluorescent lights Flicker-free lighting Lightweight fixture Built-in barn doors with hammered silver reflective surface Air-induction cooling FRC-24 has 2-bulb/4-bulb switching Built-in fuse circuit protection Padded carrying case Specifications 4 FRC-24 120VAC Amperage Bulb Type • • • • • FRC-22 Input Voltage Bulb Switching • Impact FRC-22 or FRC-24 Ready Cool Fluorescent Light Fixture Two (FRC-22) or fou
Mounting bulbs in fixture 1. Disconnect fixture from power source 3. Position bulb with printed side of base end facing up 2. Remove plastic retaining clip 4.
Mounting bulbs in fixture 5. 6. 6 Carefully slide bulb into base until the clip locks the bulb into place Be sure bulb is securely locked into base 7. Replace plastic retaining clip 8. Repeat procedure for each bulb 9. Before you turn the Ready Cool fixture on for the first time, be sure that the fuse holder on the back of the unit is turned clockwise until tight. If it’s loose, the lights will not turn on.
Removing bulbs from fixture 1. Disconnect fixture from power source 3. Push metal clip on base to release bulb 2. Remove plastic retaining clip 4. Carefully pull bulb out of base 5. Replace plastic retaining clip.
Limited One Year Warranty Impact provides a limited warranty that this product is free from defects in materials and workmanship to the original purchaser under normal use for a period of one (1) year from the original purchase date or thirty (30) days after replacement whichever occurs later. Our responsibility with respect to this limited warranty shall be limited solely to repair or replacement, at its option, of any product which fails during normal consumer use.
