FP-5982Z / FP-4367Z Panel Frame Kit INSTRUCTIONS 1
Introduction Thank you for choosing the Impact Panel Frame Kit. This lightweight portable light reflector kit helps you turn harsh direct sunlight into a well-balanced, beautifully lit photograph or video. The Panel Frame Kit comes in its own sturdy carrying bag, and can be assembled without tools in 5 minutes or less. The reversible reflector gives you the choice of a silver zebra or a gold zebra pattern.
Overview 1 2 4 1. 2. 3. 4. 3 Two (2) aluminum support poles each tethered with built-in shock cords Two (2) aluminum latching cross bars Locking latches Reversible sided panel fabric The Panel Frame helps to reduce contrast and gives you well-balanced light even in harsh sunlight. You can vary the amount of fill light by moving the reflector closer or further from your subject.
Setup - Part One 1 4 2 1. Open the carrying bag and remove all elements of the Panel Frame kit. 2. Assemble a support pole by pulling the two halves slightly apart and inserting the end of one into the other. 1 3. The shock cord will hold the two halves securely together. Assemble the other support pole in the same way. 4. Unfold the reflector and lay it out flat. 5. Insert the end of one support pole into an end of the fabric guide that runs along each of the two sides of the panel. 2 6.
3 4 7. Place the end of the pole into the small pocket at the end of the guide. 3 9. Repeat this process with the other pole along the other side of the reflector. 8. Place the other end of the pole into the small pocket at the other end of the guide. 10. The reflector should now be held flat and tight by the two support poles. 4 Specifications: • Panel Frame Dimensions – (L×H) FP-4367Z: 67 x 43” (170.2 x 109.2 cm) FP-5982Z: 82 x 59” (208.3 x 149.9 cm) • Weight FP-4367Z—Total: 9.7 lbs.
Setup - Part Two 1 6 2 1. Decide which surface you want to use. 2. On the opposite side of the reflector from the side you’re using, install the two cross bars. 3. There are three gaps in the fabric guides that hold the supporting poles. Use the two gaps nearest each end of the reflector to mount a cross bar. Do not use the gap in the middle for mounting a cross bar. 1 4.
3 4 7. Attach the latch lock in the same manner as above. The curved part of the cross bar should protrude toward you. 3 8. Repeat this process with the other cross bar in the gaps near the other end of the reflector. Note: Always be sure to keep the Panel Frame well-anchored when using it outside. Even a light breeze can move it or knock it over if it’s not properly weighted. 9. The Panel Frame is now ready for use.
One-Year Limited Warranty Impact provides a limited warranty that this product is free from defects in materials and workmanship to the original purchaser under normal use for a period of one (1) year from the original purchase date or thirty (30) days after replacement whichever occurs later. Our responsibility with respect to this limited warranty shall be limited solely to repair or replacement, at its option, of any product which fails during normal consumer use.
