User Manual

Installing Two Speedlights

For greater ﬂash power and faster recycle times, you can mount two speedlights and

radio remotes to the ﬂash bracket.

To assemble the SR-SHOE-D for two speedlights, follow these steps:

1. Mount your softbox onto the speed ring by inserting your softbox’s rods into

the corresponding labeled rod mounts (for more information on this, refer to

your softbox’s instruction manual).

2. Mount the speed ring assembly onto a light stand or boom arm, and use the

locking knob to tighten the connection until secure.

3. Insert the L bracket into the speed ring’s L-bracket mount, and use the

thumbscrew to secure its position. (Fig. 3 page 5)

4. Unscrew and remove the middle thumbscrew from the ﬂash bracket. (Fig. 5)

5. Position the ﬂash bracket so it’s curved toward the speed ring, and slide it onto

the L bracket. Use the thumbscrew to secure its position.

6. The two outer shoe mounts should be facing toward the speed ring, and the

inner ones should be facing away from it. Insert your speedlights into the outer

shoe mounts, and your radio remotes into the inner shoe mounts. Use the

small thumbscrew on the shoe mounts to loosen and tighten the mounts. (Fig .4)

Important!

Make sure the mounts and the locking mechanisms on your speedlights and radio

remotes are fully locked.

Note: You may need to experiment to ﬁnd a shoe-mount conﬁguration that works

best with your speedlights and radio receivers. The SR-SHOE-D is ﬂexible and allows

for a wide array of equipment conﬁgurations.

Assembling the Speed Ring