User Manual

Setting Up Your Background Support System
Page 6 Page 3
10M 25M 50M 75M 100M 10Y 25Y 50Y 75Y 100Y
Start with one of the stands. Unlock the
legs by turning the knob counter-clockwise.
Spread the leg sections, but maintain a low
center of gravity. Re-tighten the knob.
Raise the height of the stand by unlocking
the sections. Start with the lowest knob,
and raise each section to your desired
height. Re-tighten each knob.
1 2
Congure the second stand to match the
rst.
Place the two stands approximately
where you want the backdrop to hang.
Youll be able to adjust them once you get
the cross bar in place.
3 4
It’s a good practice to secure the legs of
your background supports with a sandbag
or weight bag.
You can unscrew the 3/8˝ spigot tops from
the support stands and use the 1/4˝-20
and 5/8˝ studs to mount lights or other
lighting equipment. Don’t lose the spigot!
13
15
14
A cloth background ready for shooting. A seamless paper background ready for
shooting.
16