User Manual

Page 18 Page 3
10M 25M 50M 75M 100M 10Y 25Y 50Y 75Y 100Y
OverviewTroubleshooting
Low Battery Indicator
Symptom
Modeling light does not work.
.
The slave sensor
does not trigger the light.
Flash does not trigger
Solution
The modeling light automatically shuts
off after ten seconds to save battery
power. When necessary, press the
modeling light button located on the
LiteTrek control panel.
Make sure that the “slave” button
located behind the light is turned on.
An LED will turn red when it is turned on.
The slave function uses a light sensor
on the back of the light. Make sure that
there is not any obstruction between
the primary ash and this sensor.
The slave function may take 15 seconds
to start up.
Ensure ash tube is seated properly.
Replace the ash tube if there are signs
of scorching, blistering, or cracks
on the tube.
DO NOT EDIT
OR REVISE ARTWORK
We will not approve any artwork
which has been altered by the vendor
FORWARD YOUR PROOFS
to [e-mail]
FOR APPROVAL
BEFORE FINAL PRODUCTION
DO NOT BEGIN PRODUCTION
WITHOUT PRIOR APPROVAL OF PROOFS
LCD Screen
Sync Input Jack
Menu Dial
Test But ton
Tilt Tension Knob
Light Stand
Locking Knob
Modeling Lamp Switch
Modeling
Lamp
Flash Tube
Optical Slave Sensor
Optical Slave
Indicator
Reector
Reector
Locking Knob
Umbrella Insert
Light Stand Mount
Power Input Jack
Optical Slave Switch