Instructions / Assembly

STEP 8
Using two #8 screws ,fasten
Roller Bracket (E) at top of
door 1/4” from edge of the
opposite panel from the
pivot bracket.
1/4”
(E)
Back View
#8 Screws
STEP 7
Insert the previous assembly
into spring hole as shown.
Fasten Bracket(H) to back of
door using two #8 screws &
test for correct installation by
pushing the Pivot Pin(G) into
door.Pin should now be
spring(F) loaded.
Back View
#8 Screws
FOR FOUR DOOR UNITS
Mount two wood blocks
end-to-end at the top of the
closet.Mount metal track end to
end with reversible plastic block
on far left and reversible plastic
block on far right. Attach oak
saddles end to end with drilled
holes on far left and far right. Complete all other steps.
Additional Step:Attach pairs of plastic door aligners ap-
proximately 2” and 36” from bottom of door.
Back Side of Bifold Door
(O)
36”
2”
STEP 12
(G)
(E)
FRONT VIEW
Slide pivot pin & roller
slowly to straight posi-
tion so that pin slides
into top pivot bracket &
into hole.Make sure that
the roller stays in
track.When pin snaps
into hole,close door
slowly making sure that there is at least 3/16” clearance
between edge of door & wall.
STEP 13
Mirror
Door
Wooden
Door
Place Handle(K) [for wooden door] & Wrap-Around
Handle [for mirror door] approx 39” from bottom of
pivot panel.Handle goes between the hinged panels on
the pivot panel.Fasten it to back of door using one #8
screw.
STEP 11
Lift to t bottom
adjusting bolt(I) into
cup on Metal Floor
Plate.
STEP 9
Screw adjusting bolt(I) into
Bottom Pivot Bracket(J) all the
way up so the door would sit as
low as possible.Insert this as-
sembly into hole at bottom of
door on the same side as Pivot
Bracket(H).Fasten Bracket to
bottom back of door
using two #8 screws.
(I)
(J)
Back View
#8 Screws
STEP 10
Fold doors together &
stand upright. Lift at an
angle to fit pivot pin &
roller into track.
Lifting at an angle with door closed
STEP 14
(Door alignment):
To adjust height alignment, turn Bottom
Adjusting Bolt to desired height.Use
wrench to adjust screw.Lock height
adjustment by screwing one #8 Screw
(n) into smallest hole at back of Bottom
Pivot Bracket.Now you can fasten the
saddle. Fasten Saddle to floor, on wood floors we recommend 10D
finish nails, first pre-drill holes using 1/8” bit to prevent wood from
splitting. Cement floors require construction adhesive.To adjust
width alignment, fold and hold doors firmly in place and loosen hex
head screws on top of plastic block and metal floor plate. Position
doors side to side for best fit and re-tighten hex head screws.
STEP 15
On the center height of the door
put wall to door Aligner(P) onto
the pivot side of the door & the
wall as shown. This will use two #8
screws for each side.
WALL
Back Of pivot Door
Pivot
Wall Bracket
Top View
#8 secrews
(P)