Warranty Information

Anchoring Instructions
The canopy / carport is designed for temporary use. Once assembled the unit MUST be securely
anchored to the ground or a permanent structure to prevent damage from wind.
Medium to Severe winds will cause damage to the frame and it to twist, unanchored legs will fall and
could cause damage to the frame, cover, or surroundings causing the roof to collapse. If severe winds or
weather is expected you must remove the cover to prevent damage, otherwise the frame could fly
away, or the cover to be ripped. A separate anchoring system is recommended for purchase the
included ground spikes and rope are NOT a secure method to SOLELY anchor the frame.
Impact Canopy Auger Style Anchoring Kit: (sold separately)
Designed to work on medium to hard surfaces, Grass; Dirt; Gravel with hard subsurface. Not to be used
on Sand, loose gravel or concrete.
Step 1: Starting at one corner - Measure 36 inches / 96.44cm from each leg. Take one of the auger
anchors and screw into the ground. Leave about 2 inched between the eyebolt and the ground.
Step 2: Using the rope 10’ increments tie around the inside 3way corner fitting or the connector on the
corner of the cover.
Step 3: Pulling the rope tight, loop through the eyebolt of the grounded anchor and securely tie.
Repeat step on all legs of the unit one side at a time. If you have an 8 let unit – repeat 8 times.
Step 4: Finish to Screw down the grounded anchors so that is it completely flush with the ground. And
equally taut on both sides of the canopy. Be sure to continuously check that all anchors and rope is taut
and secure to ensure the unit stays properly anchored. Reminder in high winds remove cover.