Quick Start Guide


NOTE: Currently there is no ‘servo reverse’ feature in Cleanflight. This means that if one of
the R/C transmitter channels is reversed, the wizard will not complete correctly.
It is highly recommended to start the wizard with a ‘new’ profile in the R/C radio, without any
channel reversing, and also without any expo. Expo is all handled within the Pro-Tuning
profiles.

All Done, Time To Fly
At this point in the Getting Started manual, the Vortex should be ready for its maiden flight.
The Wizard has setup the flight controller with our default Pro-Tune, generated by one of our
expert team pilots. PIDs and gains are unlikely to require major changes to achieve precise
flight.
If the props were removed during setup (as we highly recommend), please re-install taking care
of the prop directions below:

Take it easy for the first few LiPos, and get used to your new Vortex.
P.S. To arm the flight controller after running the wizard, for mode 2, move the throttle stick
down and to the right. See ‘Flight Controller Stick Commands’ in the main manual.



14

