Quick Start Guide
NOTE: Use the value displayed beside the bar to adjust the endpoints of your R/C transmitter
to have min@1000, center@1500, and max@2000. This is critical for correct OSD and
flight-controller operation.
NOTE: To restart the wizard at
anytime, power up the quad, press
and hold the button on the led
board until vortex beeps 2 times
(first beep after ~3 seconds,
second beep after ~5 seconds).
Alternatively you can also enter tx
Wizard via OSD menu
Once the wizard is finished,
various Cleanflight settings will
be configured, including enabling
oneshot, motor_stop, and
failsafe.
Another setting which is automatically made is the assignment of CH5 to the flight mode, Acro,
Horiz, and Angle. To complete the setup, configure your R/C Tx to link CH5 to a 3-position
switch.
Ensure that the switch correctly switches between the three flight modes, reflected in the
top-right corner of the OSD main landscape .
Note that It is highly recommended to attempt the maiden flight in either Angle, or Horiz mode.
Acro takes a little getting used to.
NOTE: Even though the flight controller failsafe has been set by the wizard, it is important to
also set the R/C Rx failsafe.
see https://github.com/cleanflight/cleanflight/blob/master/docs/Failsafe.md for cleanflight
specific failsafe test procedure.
On the EzUHF this is as easy as setting the controls in a ‘safe’ position (very low throttle for
example) and holding down the bind button on the EzUHF Tx until a beep is heard.
Flyaways with mini-quads are almost always caused by incorrect failsafe settings!
13