Operation Manual

To exit the test move the Roll stick to the left.
Appendix A: Firmware Upgrades
Both the OSD, and the Flight Controller, are updated using the USB port on the rear of the Vortex.
Prior to any upgrade, please remove all Props!. If for any reason the props spin up during a firmware upgrade,
serious damage to persons and/or property is very likely.
If your Vortex is not recognized as a valid USB device when you plug it in your PC, you will have to install a driver
first. You can download it from here: CP210x USB to UART Bridge VCP Driver
To update the OSD and Flight Controller you will need to install two chrome applications:
1. Vortex-configurator
2. Betaflight-configurator
OSD Firmware Upgrades
To upgrade the OSD, use the Vortex-configurator Chrome app, do NOT use the old ImmersionRC Tools.
Please note that you need to rerun the Tx wizard after each up- or downgrade of the OSD firmware to make
sure that the FC and OSD know the range and endpoints of your controls. Failure to do so might result in the
OSD being unresponsive to the quad exhibiting strange behavior.
34