Operation Manual

WARNING:
Be
careful
how
much
pressure
is
placed
on
this
small
button.
It
is
a
surface-mount
part
which
may
easily
be
damaged
with
a
heavy-hand.
Use
an
appropriate
tool
to
access
the
recessed
button
(a
bent
paper-clip
works
fine),
and
do
not
push
harder
after
the
first
‘click’
is
felt.
3) Synergy FC/OSD button, used to enter firmware update mode in the case of a ‘bricked’ OSD. Note that
we don’t expect this button to ever be needed, but this is where it is located just incase...
See
the

Firmware
Upgrades
chapter
for
more
details.
4) Receiver Connector (All Protocols, CPPM, SBus, DSMX, etc.)
The Vortex 150/180 Mini has a single connector for all supported receivers. 5V and 3.3V power
supplies are available, to support most of the commonly used receivers on the market today. In most
cases, one of the supplied cables will suffice, but if a cable must be built, follow the pinout below:
7