Operation Manual
WARNING:
Be
careful
how
much
pressure
is
placed
on
this
small
button.
It
is
a
surface-mount
part
which
may
easily
be
damaged
with
a
heavy-hand.
Use
an
appropriate
tool
to
access
the
recessed
button
(a
bent
paper-clip
works
fine),
and
do
not
push
harder
after
the
first
‘click’
is
felt.
3) Synergy FC/OSD button, used to enter firmware update mode in the case of a ‘bricked’ OSD. Note that
we don’t expect this button to ever be needed, but this is where it is located just incase...
See
the
Firmware
Upgrades
chapter
for
more
details.
4) Receiver Connector (All Protocols, CPPM, SBus, DSMX™, etc.)
The Vortex 150/180 Mini has a single connector for all supported receivers. 5V and 3.3V power
supplies are available, to support most of the commonly used receivers on the market today. In most
cases, one of the supplied cables will suffice, but if a cable must be built, follow the pinout below:
7










