User manual

6
Setting Channel/Band/Power using the button
First, a disclaimer, this transmitter was not designed to use the button as the primary user-
interface. The TNR Wand is by far the easiest way to configure the transmitter, and provides both
feedback of which channel a transmitter is on before it is powered up, and define the current band/
channel, and power level.
Three ‘Menu Options’ are available using the button and LED, shown in the flowchart below.
NOTE: When in Race Mode, under the control of the race director, the button will have no effect, other
than the unlock procedure below.
Emergency Unlock procedure (leaving Race Mode after an event)
If the Tramp was not removed from Race Mode after an event, a simple procedure may be followed
to manually unlock it.
Press the button on the side of the tramp before applying power, apply power, and hold the button
for 30 seconds until the LED is lit.
(Yes, we know this is tedious, but it is this way to reduce the probability of accidentally leaving race mode
at an event)