User manual

5
thin ‘carpet tape’ to ensure that the close proximity of the frame doesn’t affect the TNR range.
NOTE: For the tramp version used for events in July/Aug 2016, please connect the TNR board to the Tramp
and power it up at least once before arriving at race events. The first customer release will not require this.
Antenna Compatibility
The pigtail supplied with the Tramp sports a standard SMA connector, NOT a RP-SMA which is used
by some other manufacturers.
If a RP-SMA connector is screwed onto a standard SMA, it will appear to be connected, but will
actually be open-circuit, potentially damaging the Tx.
Ensure that one of the connectors has a pin, and the other has a hole to receive the pin. If both have
a hole (or both have a pin) then they are not compatible.
User Interface
Button/LED
Startup LED Behavior
The LED indicates the state of the transmitter shortly after powerup.
Steady On means that the transmitter is currently transmitting in ‘Normal Mode’, and will behave
much like any other FPV Transmitter.
A short blink sequence (. . . ) means that the transmitter is in Race Mode, and is either not
transmitting, or transmitting low-power on a pre-configured Pit Frequency.
A long blink sequence (- - -) means that the transmitter is in Race Mode, and is currently
transmitting on its assigned Race Frequency.