User manual




Setting Channel/Band/Power using the button
First, a disclaimer, this transmitter was not designed to use the button as the primary user-interface.
The TNR Wand is by far the easiest way to configure the transmitter, and provides both feedback of
which channel a transmitter is on before it is powered up, and define the current band/channel, and
power level.
Three ‘Menu Options’ are available using the button and LED, shown in the flowchart below.
NOTE:   When   in   Race   Mode,   under   the   control   of   the   race   director,   the   button   will   have   no   effect,   other
than   the   unlock   procedure   below.


Emergency Unlock procedure (leaving Race Mode after an event)
If the Tramp was not removed from Race Mode after an event, a simple procedure may be followed
to manually unlock it.
Press the button on the side of the tramp before applying power, apply power, and hold the button
for 30 seconds until the LED is lit.
(Yes,   we   know   this   is   tedious,   but   it   is   this   way   to   reduce   the   probability   of   accidentally   leaving   race   mode   at
an   event)

 



6
 
