User manual
Specifications
RF Output
Antenna Impedance
50 Ohms
Antenna Connector
Surface Mounted U.FL, with replaceable U.FL to SMA pigtail
Power Output
Linearly adjustable, < 1mW to > 25mW
2
Channels
40 standard, arbitrary using Race Wand
Pit Frequency
User/Race Organizer Definable
Channel Change Glitching
Eliminated using Auto-Glitch technology
Mechanical
Dimensions
L=32mm x W = 14mm x H = 5mm
Weight
4g (Tx only without SMA pigtail)
Audio/Video
Connector
JST-GH, 6-pin locking
Pinout
Battery In, Gnd, +5V Out, Video, Audio, Telemetry (twin grounds on harness)
Modulation
FM, Audio and Video
Audio
Mono input, duplicated on subcarriers on 6.0 and 6.5MHz
1
TNR (Touch’n’Race)
Connector
JST-GH, 4-pin locking
Power
Voltage
2s-4s HV LiPo
Power Consumption
~1W @ 25mW
Environmental
Storage Temperature
TBD
Operating Temperature
TBD
1
Mono audio duplicated on both audio subcarriers to eliminate noise in one channel of stereo
headphones at the (stereo) receiver.
2
Power limited by Tx temperature to extend transmitter lifetime. A hot transmitter (no airflow) will
reduce power until safe temperature is reached.
2