User's Manual

In the main interface, short press the button to enter the system menu setting interface.
Resolution: 2K + 1080P or 1080P + 1080P .
Loop Record: 1 minute / 3 minutes / 5 minutes.
Time-lapse: "Off" "1S" "2S" "3S".
When “OFF” is selected, the device will shut down automatically when the ACC is disconnected.
Select “1S”, “2S”, and “3S”: When ACC is disconnected, the device will automatically enter the time-lapse monitoring state
and record as “1S frame”, “2S frame”, and “3S frame”.
After the ACC is powered, the device exits the time-lapse monitoring and starts normal recording. (This function can only be
used when the wire is hard line , and this function cannot be used when power by cigarette lighter)
MENU SETTING
9 10
Resolution 1080P+1080P
Back
Backlight
adjustment
Video Encode Frequency USB Mode Key Voice Speaker Boot Sound Stream Language
Resolution Loop Record Time-Lapse Record Audio G-Sensor Parking Guard License Screen Saver
Record Audio: On / off can be set; when set to "Off", there will be no sound in recording video.
G-Sensor: Off / High / Medium / Low can be set; when gravity sensor is turned on, the machine is subjected to collision during
normal recording. When the collision acceleration value reaches the value set by G-Sensor (trigger sensitivity can be set as
required), then the system will Lock the currently recorded video, and the locked video will not be covered by the loop system.
Parking Monitor: Off / High / Medium / Low can be set; when the dash cam is off, if it detects vibration of the car (trigger
sensitivity can be set as required), then the recorder will automatically start recording for 20 seconds and then shut down.
License: You can set your license plate number and then display it on the recording interface and the recorded video.
Screen Saver: Off / 1 minute / 3 minutes.
Backlight adjustment: Manual / Auto can be set; when set to manual, it can be adjusted up and down on the 1/3 part of right
screen to adjust screen brightness.
Video Encode: H.264 / H.265 can be set.
Frequency: 50Hz / 60Hz.
USB Mode: Connect the device to the PC with a USB wire and directly read the data in the machine's SD card.
Key Sound: On / off can be set.
Speaker: Off / low / medium / high.
Boot sound: On / off can be set.
Stream: On / off can be set. Stream mode means the mirror screen display the rear camera as default while you restart the vehile
everytime . If switch off the stream mode . The mirror will display the front view camera instead once it power on .
Language: 8 languages optional.