Instructions

9
English
•
Always keep a minimum distance of 50 cm to
the illuminated surface.
Mounting the spotlight: Use the double bracket
to mount the spotlight, e. g. by means of a solid
mounting screw or a suitable support (Chook)
on a crossbar. To align the spotlight, release the
twolocking screws of the bracket, incline the
spotlight as desired and fasten the screws again.
WARNING Install the spotlight safely and
expertly. When the spotlight is
installed at a place where people
may walk or sit under it, addi-
tionally secure it (e. g. by means
of a safety rope on the bracket;
attach the safety rope so that the
maximum falling distance of the
spotlight will not exceed 20 cm).
Setting up the spotlight: Release the two
locking screws of the double bracket so that it
can be adjusted. Fold out the two parts of the
bracket underneath the spotlight and use them
as a stand. Then fasten the screws again.
3.2 Connection to a DMX controller
The spotlight is equipped with two 3-pole XLR
control connections (
☞
fig.1):
– a DMX input
– a DMX output
To connect multiple DMX-controlled units to
a DMXcontroller, connect the units in a chain
(
☞
fig.2). For connection, use special cables
for DMX signal transmission (e. g. cables of the
CDMXN series). For cable lengths exceeding
150 m or when controlling more than 32 units,
it is generally recommended to insert a DMX level
matching amplifier (e. g. SR-103DMX).
1) Connect the DMX output of the controller to
the DMX input of the first DMX-controlled unit.
2) Connect the DMX output of the first
DMX-controlled unit to the DMX input of the
second DMX-controlled unit. Proceed in the
same way to connect the output of the second
unit to the input of the third unit etc. until all
DMX-controlled units have been connected
in a chain.
3) To prevent interference in signal transmission,
in case of long cables or a multitude of units
connected in series, terminate the DMX out-
put of the last unit in the chain with a 120 Ω
resistor (> 0,3 W): Connect a DMX terminating
plug (e. g. DLT-123) to the output jack.
4 Operation
WARNING To prevent damage to your eyes,
never look directly into the light
source for any length of time.
Please note that stroboscope ef-
fects and fast changes in lighting
may trigger epileptic seizures with
photo sensitive persons or persons
with epilepsy!
To switch on the spotlight, connect the mains
cable to a mains socket (230 V / 50 Hz); to switch
off, disconnect the spotlight from the mains.
Note: The internal fan will start and stop depending on
the temperature inside the spotlight.
➁
DMX-controlled
unit
DMX-controlled
unit
DMX-controlled
unit
DMX-controlled
unit
DMX controller
DMX
output
DMX
output
DMX
output
DMX
output
DMX
output
DMX
input
DMX
input
DMX
input
DMX
input
DMX terminating plug
(if required)
2
1
3 4 5
6 7 8
1 2
3
2 1
3
UP DOWNMENU ENTER
DMX output
DMX input
Mains cable
DMX OUT DMX IN
➀