Instructions

17
English
4.1.4 Show programmes and
sequencesofscenes
10 show programmes ( … ) are
stored in the spotlight. Furthermore, 10 se-
quences of scenes ( … ) with up to
30 scenes can be programmed (
☞
chapter 4.1.5).
The show programmes and sequences of scenes
can be started as follows:
1) Press the button MENU repeatedly until the
display indicates .
2) Press the button ENTER. The display now in-
dicates the show programme most recently
selected ( … ) or the sequence
of scenes most recently selected ( …
).
3) Use the button UP or DOWN to select the show
programme or sequence of scenes desired.
4.1.5 Programming sequences of scenes
10 sequences of scenes can be easily programmed.
A sequence may consist of up to 30scenes which
is automatically repeated. For each scene, the
colour can be set along with its brightness, the
stroboscope function can be activated with a var-
iable flash rate, and the duration of the scene as
well as the fading time can be defined.
1) Press the button MENU repeatedly until the
display indicates .
2) Press the button ENTER. The display now
indicates the number of the sequence most
recently changed ( … ).
3) Use the button UP or DOWN to select the
number under which the sequence of scenes is
to be stored, and then press the button ENTER.
The display indicates the number of the first
scene ( ).
4) Press the button ENTER to call up the following
setting functions one after the other:
= brightness of red
= brightness of green
= brightness of blue
= brightness of white
= brightness of amber
= brightness of UV
= flash rate of the stroboscope
= duration of the scene in seconds
= fading time
Use the button UP or DOWN to set the value
desired.
5) After setting the first scene, press the button
MENU. The display indicates the number of the
scene again. Use the button UP to select the
second scene, press ENTER and then select the
settings for this scene. Repeat this procedure
for the following scenes. If not all 30 scenes
are required, enter 0 as the value for the
numbers of scenes that are not to be used.
4.2 Synchronous control of multiple
spotlights (master / slave mode)
Multiple PARC-100 / COL may be connected. The
master unit can then control all slave units in sync.
1) Connect the spotlights via their DMX jacks to
a chain. Please refer to chapter 4.3.1 “Con-
nection”, ignoring step 1.
2) The master unit must be defined as the master
unit; the units that are to be controlled by the
master unit must be defined as slave units:
a) Press the button MENU repeatedly until the
display indicates .
b) Press the button ENTER and then use the
button UP or DOWN to select:
= master unit
= slave unit
3) Any sequences of scenes that have been
stored on the master unit (chapter 4.1.5) may
be copied to the slave units:
a) On the master unit, press the button MENU
repeatedly until the display indicates .
b) Press the button ENTER. The display indi-
cates
, , , , or
.
c) Press the button UP or DOWN repeatedly
until the display indicates
.
d) Press the button ENTER so that the display
indicates four entry positions (. . . .). Then
press the following buttons:
UP, DOWN, UP, DOWN.
Each time one of these buttons is pressed,
an asterisk (
) will appear on the display.
e) Press ENTER to start copying. During copy-
ing, the spotlight lights up in yellow. If an
error occurs, the spotlight will light up in
red. Upon successful completion, the spot-
light will light up in green.
f) To switch on the operation mode desired,
press the button MENU so that the display
indicates
again. Use the buttons UP
and DOWN to select the operating mode
and then press ENTER to activate it.