Instructions

15
English
3 Setting the Spotlight
intoOperation
3.1 Installation
•
Always position the spotlight in such a way to
ensure sufficient air circulation during operation.
Never cover the cooling fins of the housing.
•
Always keep a minimum distance of 50 cm to
the illuminated object.
WARNING When the spotlight is installed at
a place where people may walk or
sit under it, additionally secure it,
e. g. via a safety rope. Guide the
safety rope through the eyebolt
on the rear of the spotlight and fasten it in such
a way that the maximum falling distance of the
spotlight will not exceed 20 cm.
1. Install the spotlight via its mounting brackets,
e. g. with a stable mounting screw or a support
for lighting units (C hook) on a cross bar.
To align the spotlight, release the two lock-
ing screws of the mounting brackets. Adjust
the desired inclination of the spotlight and
fasten the screws.
2. Alternatively, set up the spotlight on its own:
Fold out the mounting brackets underneath
the spotlight and use them as a stand. Then
fasten the locking screws.
3.2 Barn doors
To reduce the light beam angle, optional barn
doors are available: PARC-100B. Fasten the barn
doors to the front of the spotlight.
3.3 Power supply
For power supply, the unit is equipped with
Power con connections.
CAUTION! Never connect or disconnect a Power-
con plug while voltage is applied. Always make
the Powercon connection before making the
mains connection. When disconnecting, always
disconnect the mains connection before discon-
necting the Powercon connection.
1) Connect the blue Powercon plug of the mains
cable supplied to the Powercon jack POWER
IN and turn the plug clockwise until it locks.
(To disconnect the cable from the unit, pull
back the safety latch on the plug, turn the
plug counter-clockwise and remove it from
the jack.) Then connect the mains plug of the
cable to a mains socket (230 V/ 50 Hz).
2) When the spotlight has been connected to the
mains, it is switched on. The display will show
the menu item most recently selected and go
out after 30 seconds. As soon as a button
(MENU, ENTER UP und DOWN) is pressed, the
display will light up again for 30 seconds.
WARNING
To prevent damage to your eyes,
never look directly into the light
source for any length of time.
Please note that stroboscope effects and fast
changes in lighting may trigger epileptic sei-
zures with photosensitive persons or persons
with epilepsy!
Power supply of
multiple PARC-100 / COL spotlights
If multiple PARC-100 / COL spotlights are used,
the jack POWER OUT of the first spotlight can
be connected to the mains jack POWER IN of
the second spotlight. For this, a mains cable with
Powercon plugs (NAC-3FCB and NAC-3FCA) is
required. Proceed in the same way to connect the
second spotlight to the third spotlight etc. until
all spotlights have been connected in a chain.
Thus, up to 19 spotlights can be interconnected.
The jack POWER OUT can also be used for power
supply of other (light effect) units.
CAUTION! To reduce the risk of fire caused by
overload, the current load of the cables and the
mains plug must not exceed 10 A.