User manual

19
English
6.4 Temperature indication and
overheatcontrol
The spotlight is equipped with an overheat control.
When the temperature inside the spotlight is too
high, the spotlight will be switched off. After cool-
ing down, the spotlight will be switched on again
automatically. To indicate the inside temperature:
1) Press the button MENU repeatedly until the dis-
play indicates .
2) Press the button ENTER.
3) When is indicated, press the button ENTER.
The inside temperature will be indicated in °C.
4) To exit the menu branch, press the button MENU.
6.5 Resetting the spotlight
toitsfactorysettings
The factory settings of the spotlight are as follows:
Function Factory setting
number of DMX channels
= 10 channels
max. brightness
= 100 %
white balance function
subaddress function
slow LED response
= slowest
subaddress 01
11 shades of white factory settings
white balance
R = 255, G = 255,
B= 255
DMX / independent mode or
slave mode
= DMX / inde-
pendent operation
To reset the spotlight to its factory settings:
1) Press the button MENU repeatedly until the high-
est menu level has been reached.
2) Press the button UP or DOWN repeatedly until
the display indicates .
3) Press the button ENTER. The display changes to
, , , , or .
4) Press the button UP or DOWN repeatedly until
the display indicates .
5) Press the button ENTER so that the display indi-
cates four entry positions (. . . .). Then press the
following buttons:
UP, DOWN, UP, DOWN.
Each time one of these buttons is pressed, an
asterisk ( ) will appear on the display.
6) To reset the settings, press the button ENTER (the
display briefly indicates ) or, to cancel the
procedure, press the button MENU.
7) To be able to control the spotlight by DMX, use
the button MENU to return to the highest menu
level. For an independent operation, use the but -
ton MENU to select the operating mode and then
press ENTER to activate the mode selected.
7 Cleaning the Spotlight
Clean the plastic filter in front of the LEDs at regular
intervals or as required. This is the only way to ensure
that light will be radiated at maximum brightness.
Before cleaning, disconnect the mains plug from
the socket. Only use a dry, soft cloth and a mild
detergent. Then carefully wipe the plastic filter dry.
For cleaning the other parts of the housing, only
use a dry, clean cloth. Never use any fluid, it may
leak into the spotlight and damage it.
8 Specifications
Data protocol: . . . . . . . . . . DMX 512
Number of DMX channels:
selectable:
3, 4, 5 or 10
Light source:
. . . . . . . . . . . RGB COB LED
Power consumption
PARC-56 / RGB: . . . . . . 50 W
PARC-64 / RGB: . . . . . . 100 W
Beam angle: . . . . . . . . . 60°
Power supply:
. . . . . . . . . . 230 V/ 50 Hz
Power consumption
PARC-56 / RGB:. . . . . . . . 60 VA max.
PARC-64 / RGB:. . . . . . . . 110 VA max.
Dimensions
PARC-56 / RGB:. . . . . . . . ⌀ 185 mm × 210 mm
PARC-64 / RGB:. . . . . . . . ⌀ 220 mm × 260 mm
Weight
PARC-56 / RGB:. . . . . . . . 2.4 kg
PARC-64 / RGB:. . . . . . . . 2.9 kg
Subject to technical modification.
All rights reserved by MONACOR
®
INTERNATIONAL GmbH &
Co. KG. No part of this instruction manual may be reproduced
in any form or by any means for any commercial use.