User manual

23
English
5.4 Resetting the spotlight
toitsfactory settings
The factory settings of the spotlight are as fol-
lows:
Menu
item
Function Factory setting
number of DMX channels
= 10 channels
max. brightness
white balance function
subaddress function
slow LED response
= 100 %
= slowest
subaddress 01
11 shades of white factory settings
white balance
R = 255, G = 255,
B= 255
DMX / independent mode
or slave mode
= DMX / inde-
pendent operation
Fig. 13 Factory setting
To reset the spotlight to its factory settings:
1) Press the button MENU repeatedly until the
highest menu level has been reached.
2) Press the button UP or DOWN repeatedly until
the display indicates .
3) Press the button ENTER. The display indicates
, , , , or .
4) Press the button UP or DOWN repeatedly until
the display indicates .
5) Press the button ENTER so that the display
indicates four entry positions (. . . .). Then press
the following buttons:
UP, DOWN, UP, DOWN.
Each time one of these buttons is pressed, an
asterisk ( ) will appear on the display.
6) To reset the settings, press the button ENTER
(the display briefly indicates ) or, to cancel
the procedure, press the button MENU.
7) To be able to control the spotlight by DMX,
use the button MENU to return to the highest
menu level.
For independent operation, use the button
MENU to select the operating mode and then
press ENTER to activate the mode selected.
6 Cleaning the Spotlight
Clean the pane in front of the LED at regular inter-
vals depending on impurities. This is the only way
to ensure that light will be emitted at maximum
brightness. Before cleaning, disconnect the
mains plug from the socket. Only use a soft
clean cloth and a glass cleaner.
For cleaning the other parts of the housing of
the PARC-100 / RGB, only use a soft clean cloth.
Never use any fluid; it may leak into the spotlight
and damage it.
The weatherproof housing of the ODC-
100 / RGB may also be cleaned with a damp cloth
and a mild detergent.
7 Specifications
Data protocol: . . . . . . . . . . DMX 512
Number of DMX channels:
selectable: 3, 4, 5
or 10
Light source: . . . . . . . . . . . RGB COB LED
Power consumption: . . .100 W
Beam angle: . . . . . . . . . 60°
DMX connections:
. . . . . .XLR, 3 poles
Pin assignment: . . . . . . . Pin 1 = ground
Pin 2 = DMX−
Pin 3 = DMX+
Power supply: . . . . . . . . . . 230 V/ 50 Hz
Power consumption: . . . . .120 VA max.
Protection of housing: . . . .IP 66 (ODC- only)
Dimensions w/o
mounting bracket:
. . . . . .⌀ 185 × 250 mm
Weight: . . . . . . . . . . . . . .6.5kg
Subject to technical modification.
All rights reserved by MONACOR
®
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may be
reproduced in any form or by any means for any commercial use.