User manual

14
Deutsch
Deutsch Seite
Français
Français Page
Italiano
Italiano Pagina
Nederlands
Nederlands Pagina
Español
Español Página
Polski
Polski Strona
English
English Page
English
1 Applications. . . . . . . . . . . . . . 14
2 Safety Notes . . . . . . . . . . . . . 14
3 Setting the Spotlight intoOperation . . 15
3.1 Installation . . . . . . . . . . . . . . . 15
3.2 Barn doors . . . . . . . . . . . . . . . 15
3.3 Power supply . . . . . . . . . . . . . . 15
3.3.1 ODC-100 / RGB . . . . . . . . . . . . . 15
3.3.2 PARC-100 / RGB . . . . . . . . . . . . 16
4 Operation . . . . . . . . . . . . . . . 16
4.1 Independent operation . . . . . . . . . . 16
4.1.1 Colour spotlight and stroboscope . . . . . 16
4.1.2 Different shades of white
Storing 11 shades of colour
. . . . . . . 16
4.1.3 Music control . . . . . . . . . . . . . 17
4.1.4 Show programmes and sequencesofscenes 17
4.1.5 Programming sequences of scenes. . . . . 17
4.2 Synchronous control of multiple spotlights
(master / slave mode) . . . . . . . . . . . 18
4.3 Operation with a DMX controller . . . . . . 18
4.3.1 Connection . . . . . . . . . . . . . . 18
4.3.2 Setting the number of DMX channels . . . 19
4.3.3 Setting the DMX start address . . . . . . 19
4.3.4 Using subaddresses . . . . . . . . . . . 20
4.3.5 Functions of the DMX channels . . . . . . 21
5 Additional Functions. . . . . . . . . . 21
5.1 Maximum brightness ofthespotlight . . . . 21
5.2 White balance. . . . . . . . . . . . . . 22
5.3 Slow response of the LEDs . . . . . . . . 22
5.4 Resetting the spotlight toitsfactory settings . 23
6 Cleaning the Spotlight. . . . . . . . . 23
7 Specifications . . . . . . . . . . . . . 23
DMX LED Spotlight
These instructions are intended for users with
basic knowledge in DMX control. Please read the
instructions carefully prior to operation and keep
them for later reference.
On page 2, you will find the spotlights ODC-
100 / RGB and PARC-100 / RGB. The menu for the
settings of the spotlight can be found on pages
78 and 79.
Contents
1 Applications
This LED spotlight is used for illumination, e. g.
on stage, in discotheques and function rooms.
The light source is a powerful COB LED (COB =
chip-on-board technology): Many individual LED
chips are densely packed on a PCB to provide a
uniform light distribution.
The spotlight is designed for control via a
DMX light controller (3, 4, 5 or 10 DMX con -
trol channels), but it can also be operated in-
dependently without a controller. The ODC-
100 / RGB is weatherproof (IP 66) and therefore
also suited for outdoor applications.
2 Safety Notes
The spotlight corresponds to all relevant directives
of the EU and is therefore marked with .
WARNING The spotlight uses dangerous
mains voltage. Leave servicing to
skilled personnel; inexpert han-
dling may result in electric shock.
•
The spotlight PARC-100 / RGB is suitable for
indoor use only. Protect it against dripping
water and splash water, high air humidity and
heat (admissible ambient temperature range:
0 – 40 °C).
The spotlight ODC-100 / RGB is suitable for out-
door applications (admissible ambient temper-
ature range: −20 to +40 °C).
•
Immediately disconnect the mains plug from
the socket
1. if the spotlight or the mains cable is visibly
damaged,
2. if a defect might have occurred after the
spotlight was dropped or suffered a similar
accident,
3. if malfunctions occur.
In any case the spotlight must be repaired by
skilled personnel.
•
Never pull the mains cable to disconnect the
mains plug from the socket, always seize the
plug.
•
For ODC-100 / RGB only: A damaged mains
cable must be replaced by skilled personnel
only.
•
No guarantee claims for the spotlight and no
liability for any resulting personal damage or
material damage will be accepted if the spot-
light is used for other purposes than originally