Operating instructions

EN
15
TROUBLESHOOTING
This chapter describes the most common problems related using the appliance. If the
problems cannot be resolved with the information below, please contact the Authorised
Service Centre.
Problem Possible cause Solution
The plate (9)
remains cold or
does not heat up.
There is no power supply.
Verify whether the plug (11) is inserted
correctly or try inserting it in another
socket.
Verify whether the temperature
adjustment knob (2) is set to the
minimum temperature Ø (Fig. D).
The plate
temperature LED
ƺʸƻ½Å»ÉÅÄ·ÄºÅŮƔ
Normal procedure.
The switching ON and OFF of the
LED indicates the heating phase of
ʾ»¿ÈÅÄƔƺʸƻ½Å»ÉÅŮÅĹ»ʾ»É»Ê
temperature is reached.
Only a little steam
or none at all is
dispensed.
The steam selector (5) is
set to Ø.
Set the steam selector (5) to the
º»É¿È»ºŰ»Âºƺ¿½ƔƻƔ
There is not enough water
in the reservoir (10).
Fill the reservoir (10).
The impurities that
come out from the
steam holes
stain the
garments.
Chemical additives,
scented liquids or
descaling agents are being
used.
These substances damage the
product: do not use additives in the
water in the reservoir.
Pure distilled water or
softened water is being
used.
Mix tap water (50%) with distilled and/
or demineralised (50%) water.
Starch is being used.
Always spray the starch on the reverse
side of the fabric.
Water leaks from
the plate (9).
The plate temperature
is too low due to the
Super-steam button being
pressed too often (4).
Allow slightly longer intervals between
the jets of steam.
The temperature
adjustment knob (2) is set
to a temperature that is too
low (Fig. D).
Turn the temperature adjustment knob
(2) to the Max level (Fig. D).