Operating instructions
EN
13
USE
FILLING THE RESERVOIR
Verify that the plug (11) is disconnected from the socket.
Set the steam selector (5) to 0 [Fig. B].
Æ»Äʾ»Â·Ê¹¾ƺʽƻƔ
Set the iron in a position that facilitates filling the water and prevents it from overflowing.
Slowly pour the water into the reservoir (10) using the special cup (12) [Fig. C].
Do not exceed the maximum fill-up level (8) indicated on the reservoir (10).
ÂÅɻʾ»¾·Ê¹¾ƺʽƻƔ
SELECTING THE TEMPERATURE
Set the iron upright.
Insert the plug (11) in the socket.
Set the temperature according to the type of fabric in line with the international symbols
shown on the labels; using the adjustment knob (2), [Fig. D].
The plate temperature LED (1) indicates that the iron is warming up.
Wait for the plate temperature LED (1) to go off before starting to iron.
Consult the table below for the correct temperatures.
Garment
label
Fabric
ÊÏÆ»
Temperature
selector
synthetics
e.g. viscose, polyester
Ʒ
silk, wool
ƷƷ
cotton, linen
ƷƷƷ
Ƽƽ
Follow the instructions in the “steam ironing” section, leaving the steam selector (5) set to 0.
IRONING WITH STEAM
Select the amount of steam via the steam selector (5).
Move the steam selector (5) to any position between minimum and maximum according to
the desired amount.
Continuous steam will only be dispensed when the iron is in a horizontal position.
This stops when the iron is set upright or the steam selector (5) is set to 0.
Steam can only be used at the highest temperatures, as indicated by the symbol on the
temperature adjustment knob (2) [Fig. D].
If the selected temperature is too low, water droplets may drip from the plate.
·ÈĿĽÉƓ the plate temperature LED (1) goes on intermittently while ironing, thereby
indicating that the selected temperature is maintained.
Ɨ
Press the super-steam button (4) to generate a strong shot of steam that penetrates the
fabric and eliminates the most difficult creases [Fig. E].
Wait a few seconds between each pressing action of the iron.