Quick Guide

6
3.3
Tools Preparations
 Phillips screwdriver
 Antistatic wrist strap or antistatic gloves
 Drill
 Tape measure
 Marker
 Plenty of silicone rubber
 Silicone gun
3.4
Installation Steps
1. Determine the position of the 86*86mm
wall-mounted junction box.
This installation mode embeds an 86*86mm
junction box in the wall in advance or makes
a hole on the wall to embed the box.
NOTE!
There are two installation holes on the 86*86mm
wall-mounted junction box. They can be parallel to
the ground or vertical to the ground. They need to
map to intermediate holes on the bracket during
actual installation.
2. Determine the positions of holes
on the wall by referring to the
positions of four holes A on the
installation sticker.
Wall
Determine
the positions
of installation
holes on the
wall based
on the four
holes A.