Owner Manual
INTRODUCTION
Installing the IMC Teddy Storage Cabinet is a straightforward procedure that can be accomplished with normal
construction materials and techniques. Installation procedures may vary due to eld conditions and state
regulations. Please note that the following instructions are recommendations only. The installer is responsible
for proper setting and making sure the appropriate codes are followed. Please contact the IMC Teddy Engineering
Department (800-221-5644) prior to considering retrot installations.
Please read the attached information carefully, as much of the information provided is reecting proven
installation techniques used in previous installations.
Parts Included
Tools/Materials Needed
Position storage cabinet at against
wall.
Make sure cabinet is on even ground
& not wobbly.
Drill 2-3 screws through the back of
the storage cabinet (lower-middle
area) to rmly secure to the wall.
• SC Storage Cabinet
• Shelf Support Clips (10)
• S/S Shelves (5)
• Set of 2” Screws
• Drill with
3
⁄32” Bit
Shown w/ Sloped Top
& Hinged Glass Doors w/ Lock
Note: If cabinet length is larger than
48”, use 4 screws to secure to wall.
Step 1:
Step 2:
S/S Shelves
Shelf Support Clips
SC Storage Cabinet
Insert Screw Here
Rear of Storage Cabinet
Wall
Position Flat
Floor
Drill