Owner Manual
INTRODUCTION
Assembling the IMC Teddy Shelving is a straightforward procedure that can be accomplished with normal
construction materials and techniques. Please note that the following instructions are for BL, ES, S, SX, UP
Shelving with Post Legs and are recommendations only. If your shelving unit includes Casters please refer
to our other assembly guide. The installer is responsible for proper setting. Please contact the IMC Teddy
Engineering Department (800-221-5644) prior to considering retrot installations.
Please read the attached information carefully, as much of the information provided is reecting proven
installation techniques used in previous installations.
Parts Included
Tools/Materials Needed
• Solid or Louvered Shelving Units (2 or more)
• Post Legs w/ Feet (4)
• Casters (4) [if applicable]
• Post Caps (4)
• 18¼” Wood Blocks (10)
• Allen Key
• Spirit (Bubble) Leveler (optional)
• Wrench (if necessary)
• Mallet (if necessary)
Assembly Instructions
Remove set screw tape from all 4 gussets
for all shelving units.
To set the rst shelf in position, it is
recommended to place the shelf unit
upside down & on top of blocks of wood.
Use a leveler to make sure shelf surface is
leveled. (See image to the right)
Step 1:
Step 2:
Leveler
Post Leg w/
Feet
Post Caps
Casters
Wooden Blocks
Shelving Unit
Remove Tape
Gusset
Set Screw
Shelf
Solid Shelf
Louvered Shelf