Instruction manual

5
The following diagram shows a typical application and with three possible
configurations.
End-to-End Connection Switch TX/FX
Half-Duplex Configure HDX manually Auto Negotiation is OFF
Full-Duplex Configure FDX manually Auto Negotiation is OFF
Full-Duplex Auto Negotiation is ON Auto Negotiation is ON
Configure Auto Negotiation on a PSE-McBasic by adjusting the DIP Switch setting (for
unmanaged modules) or via the management software. Refer to the DIP Switch table
for switch location and settings.
AutoCross Feature for Twisted Pair Connection
All twisted pair ports on the PSE-McBasic includes AutoCross, a feature that
automatically selects between a crossover workstation and a straight-through
connection depending on the connected device.