Instruction manual

1
About the McBasic 10/100 Module
The McBasic 10/100 module is a low-cost, standalone, IEEE 802.3 single-conversion
media converter which converts between:
• 10Base-T twisted pair and 10Base-FL multi-mode or single-mode fiber
• 100Base-TX twisted pair and 100Base-SX multi-mode fiber or 100Base-FX single-
mode fiber
The McBasic 10/100 is a 1U high, standalone unit that includes diagnostic LEDs for
each port and an internal, universal (100/240 VAC) power supply.
Installing the McBasic 10/100
The McBasic 10/100 comes ready to install. The only adjustments that may need to
be made after installation are:
• Configuring the mode of operation and other features on the unit.
• Setting the twisted pair port for a crossover workstation or pass-through
connection.
To install McBasic 10/100:
1. First make sure the unit is placed on a suitable flat surface, leaving some space
at the back of the unit.
2.
Attach the cables between the McBasic 10/100 and each device that will be
interconnected.
3.
Plug the unit into a reliable, filtered power source.
NOTE
All network cables must be connected before the link LEDs will glow.