Instruction manual

Remote Management

This option allows the user to enable Remote management on the module.

The

remote management feature is designed to work only on the remote module of

the Local/Remote pair

. With Remote management enabled, the user can easily

perform the following:

•

Test the line integrity of the remote copper port.

•

Use the Local unit to configure all SNMP-configurable features for both units.

•

Use the Local unit to download firmware for both units.

Refer to the

Module LED Functions

section for more information.

NOTE

When the user enables the Remote management feature on the remote module, it is

necessary to disable SNMP-management on the chassis in which the remote unit is

installed (i.e. turn the iMediaCenter chassis SNMP switch off, or do not install an SNMP

Management module in either an iMediaChassis or iMcV series chassis.

Monitor/Boost Mode

This option allows the user to boost the UTP receive signal (i.e internal linear gain

boost). This helps the UTP receiver to compensate for line loss.

NRZ (Non-Return-to-Zero)

This option allows the user to enable or disable the NRZ mode.

NOTE

There are currently no applications that use any other settings than

AMI encoding

and

NRZ disabled

(Passive mode). Enabling NRZ can result in data corruption.

Enabling NRZ terminates the line coding on the copper line. This forces the module

to send raw data to the fiber line without line code information.