Instruction manual

11
Switch Settings for Switch S3
Jitter Attenuator Select
S3-1: ON Place Jitter Attenuator on RCV Side
S3-1: OFF Place Jitter Attenuator on XMT Side default
Remote Management
S3-2: ON Remote Management Enabled (only at the REMOTE end)
S3-2: OFF Remote Management Disabled (only at the LOCAL end) default
Loopback Selection iVIEW
2
S3-3: ON S3-4: ON None
iVIEW
2
default
S3-3: OFF S3-4: ON Local Loopback
iVIEW
2
S3-3: ON S3-4: OFF Analog Loopback
iVIEW
2
S3-3: OFF S3-4: OFF Remote Loopback
iVIEW
2
Monitor/Boost Mode
S3-5: ON S3-6: ON Normal Operation (No Boost) default
S3-5: OFF S3-6 ON 20 dB
S3-5: ON S3-6 OFF 26 dB
S3-5: OFF S3-6 OFF 32 dB
NRZ Selection iVIEW
2
S3-7: ON Disable NRZ (Required for Passive Mode)
iVIEW
2
default
S3-7: OFF Enable NRZ (Line Terminating Mode)
iVIEW
2
Fiber Type
S3-8: Factory Configured DO NOT CHANGE
S3-9: Factory Configured DO NOT CHANGE
S W I T C H S 3
S3-10: Factory Configured DO NOT CHANGE
DIP Switch Table
All iView
2
enabled switches are overridden by management software.