Instruction manual
8
This feature can be controlled by SNMP-Management software (iView
2
) when the
HOST iMcV-T1/E1/J1-LineTerm module is installed in a managed chassis.
T1, E1 and J1 Selection
This switch selects the data rate to use on the copper line. The data rate selections
available include the following:
•
T1/J1
(1.544 Mbps +/- 32 ppm)
•
E1
(2.048 Mbps +/- 32 ppm)
By default this feature is set to
T1.
This feature can be selected only by setting the DIP Switches manually.
Remote Management
A DIP Switch enables or disables the Remote Management mode. By default this
feature is Disabled. Remote Management must be enabled on the REMOTE module.
This allows all SNMP-configurable features for the REMOTE modules to be configured
from the HOST module.