Instruction manual

1
About the iMcV-LIM 10/100
The iMcV-LIM is an SNMP-manageable, IEEE 802.3 single-conversion media
conversion module which converts between:
• 10Base-T twisted pair and 10Base-FL multi-mode or single-mode fiber, or
• 100Base-TX twisted pair and 100Base-SX multi-mode fiber, 100Base-FX single-
mode fiber or single-strand single-mode fiber.
The iMcV-LIM requires one slot in an SNMP-manageable chassis or an unmanaged
chassis from IMC Networks. The iMcV-LIM features one RJ-45 connector and one
pair of ST or SC fiber connectors.
Configuring Instructions
The iMcV-LIM has user-configurable features (e.g., FiberAlert (FA), Link Fault
Detection (LFD) and Auto Negotiation (AN). Refer to the iMcV Module DIP Switch
Configuration Table for information on available features. Instructions for configuring
both managed (via an SNMP-compatible management application like iView²) and
unmanaged modules follow.
Installing an iMcV-LIM 10/100
The iMcV Modules install in IMC Networks’ SNMP manageable iMediaChassis series
or in any MediaChassis.
NOTE
All modules are hot-swappable.
To install an iMcV Modules:
1.
Remove the blank bracket covering the slot where the module is to be installed
by removing the screws on the outside edges of the bracket.
2.
Slide the iMcV Modules into the chassis, via the cardguides, until the module is
seated securely in the connector.
3.
Secure the module to the chassis by tightening the captive screw.
4.
Save any “blanks” removed during installation for future use if the configuration
requirements change.