Instruction manual

9
Notes
2
Configuration Instructions
iMcV-Gigabit Modules have user-configurable features. Instructions for configuring
both managed (via an SNMP-compatible management application such as iView²)
and unmanaged iMcV-Gigabit modules follow.
Managed Modules
To manage one or more iMcV-Gigabit Modules, an SNMP agent must be present in
the chassis: iMediaCenter chassis have embedded management; iMediaChassis
series chassis use an SNMP management module. To configure managed modules,
install the module first, and then configure using the management software. Refer to
the iView² for MediaConverters online help file for more information and assistance.
NOTE
Management software will override hardware settings (e.g., jumper, switch, etc.), so
you must configure a module that will be managed via the software. Until you
configure a managed module via the software, the module (and its LEDs) may not
work properly.
Unmanaged Modules
Before installing, configure iMcV-Gigabit Modules for desired features. The diagrams
below show the switch location on iMcV-Gigabit. The chart below states the
available features and settings for each module. After configuring the switch for the
desired settings, install the module (see page 9) and connect the appropriate cables.
iMcV-Gigabit -00
S1
8
7
6
5
43
2
1
ON
} } } }
}
Se t at
Facto ry
DO N OT
CH ANGE
Duplex Settting
DO N OT CHANGE
FiberAlert
Repeater/Switch Mode
IMcV-Gigabit -10
DI SA BLE ENA B LE
S1
8
7
6543
2
1
ON
} } } }
}
Set at
Factory
DO N OT
CH ANGE
Forced/Preferre d
TX LinkLoss
FiberAl ert
}
-Negotiation
DI SA BLE ENA BLE
All
other part numbers, including RoHS 50-1482X and 50-1483X