Instruction manual

3
LED Operation
LED Function (VDSL)
RAI
The Remote Alarm Indication led is YELLOW when the unit at
the far end of the Unit has an alarm
FL
Fault Loopback will be ON GREEN if this function is enabled
and BLINK if it is actively inhibiting the Ethernet port due to a
LOS of the VDSL line
LOS The LOS led is RED when the VDSL port is down.
ER The ERROR led will Blink YELLOW when the VDSL line
receives a symbol error. ON if the VDSL bandwidth falls below
the user defined level.
LINK Quality
8-4-2-1
These 4 GREEN LEDs form a binary code indicating the MAX
bandwidth the VDSL line can support as described in
Maximum Bandwidth IE-iMcV-VDSL2-LANextender Link LEDs.
Blinks slow GREEN at power up.
Blinks fast GREEN when line connection has been established.
Glows GREEN when VDSL is valid and working.
LED Function (DATA)
OVF Overflow LED will Blink YELLOW when frames are lost due to
congestion on the VDSL line.
LFPT
Link Fault Pass-Through will be ON GREEN if this function is
enabled and BLINK if it is actively inhibiting the Ethernet port
due to a LOS of the far end TX line.
LOS The LOS led is RED when the TX port is down.
ER The ER led is YELLOW when the TX port receives an error.
The VDSL2 will generate a Trap (when enabled in iView
2
) whenever a Loss of Signal
(LOS) occurs. In addition, the end user can set a VDSL Quality Level that will
generate a Trap if the line fails below that set level.