IE-iMcV-ModeConverter Operation Manual
FCC Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a Class B computing device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
Table of Contents FCC Radio Frequency Interference Statement ....................................................ii Warranty............................................................................................................ii About the IE-iMcV-ModeConverter ....................................................................1 Configuration Instructions ..................................................................................1 Managed Modules ................................................
About the IE-iMcV-ModeConverter The IE-iMcV-ModeConverter is SNMP-manageable and installs in the modular, SNMP-manageable iMediaChassis series and in the unmanaged MediaChassis series. The IE-iMcV-ModeConverters are protocol-independent modules with SFP ports which can provide a single conversion between single-mode and multi-mode fiber, single-mode to single-mode or multi-mode fiber to single strand single-mode fiber. The supported transmission speeds are: 10-155 Mbps and 622-1250 Mbps.
Unmanaged Modules Before beginning installation of the IE-iMcV-ModeConverter, configure it for the desired features. The chart states the available features and settings. After configuring the DIP Switches for the desired settings, install the module and connect the appropriate cables (refer to the Installation section for more information).
Installation The IE-iMcV-ModeConverter Modules install in any IMC Networks SNMPmanageable iMediaChassis series or in any MediaChassis. To install an IE-iMcVModeConverter Module, remove the blank bracket covering the slot where the module is to be installed by removing the screws on the outside edges of the bracket. Slide the IE-iMcV-ModeConverter Module into the chassis, via the card guides, until the module is seated securely in the connector.
LED Operation Each IE-iMcV-ModeConverter features diagnostic LEDs that provide information on features and ports. PWR Power—indicates power is provided to the module Glows green when unit is powered on and running Off when unit is not powered (not operating).
Installation Troubleshooting If the MSA LEDs do not light, check that the same speed has been installed. The MIS LED should indicate this condition. Specifications Power Consumption (Typical @ 5V): 422mA with SFP ports populated Operating Temperature -40°F to +185°F (-40°C to +85°C) Storage Temperature -40°F to +185°F (-40°C to +85°C) Humidity 5 to 95% (non-condensing); 0 to 10,000 ft. altitude Dimensions Single Slot iMcV module IMC Networks Technical Support Tel: (949) 465-3000 or (800) 624-1070 (in the U.
Fiber Optic Cleaning Guidelines Fiber Optic transmitters and receivers are extremely susceptible to contamination by particles of dirt or dust, which can obstruct the optic path and cause performance degradation. Good system performance requires clean optics and connector ferrules. 1. Use fiber patch cords (or connectors, if you terminate your own fiber) only from a reputable supplier; low-quality components can cause many hard-to-diagnose problems in an installation. 2.
Electrostatic Discharge Precautions Electrostatic discharge (ESD) can cause damage to any product, add-in modules or stand alone units, containing electronic components. Always observe the following precautions when installing or handling these kinds of products 1. Do not remove unit from its protective packaging until ready to install. 2. Wear an ESD wrist grounding strap before handling any module or component.
Safety Certifications CE: The products described herein comply with the Council Directive on Electromagnetic Compatibility (2004/108/EC) For further details, contact IMC Networks. Class 1 Laser product, Luokan 1 Laserlaite, Laser Klasse 1, Appareil A’Laser de Classe 1 European Directive 2002/96/EC (WEEE) requires that any equipment that bears this symbol on product or packaging must not be disposed of with unsorted municipal waste.
19772 Pauling y Foothill Ranch, CA 92610-2611 USA TEL: (949) 465-3000 y FAX: (949) 465-3020 www.imcnetworks.com © 2009 IMC Networks. All rights reserved. The information in this document is subject to change without notice. IMC Networks assumes no responsibility for any errors that may appear in this document. IE-MiniFiberLinX-II is a trademark of IMC Networks. Other brands or product names may be trademarks and are the property of their respective companies.
