Instruction manual

3
Cascading Power
When installing multiple IE-Giga-MiniMc units on a DIN rail, connect to
one DC input source and then cascade from one
DC block to the next, until reaching the maximum
electrical current available.
DIN Rail Mounting
The IE-Giga-MiniMc ships from the factory with DIN clips, allowing installation on a
DIN rail. The IE-Giga-MiniMc mounts perpendicular to the DIN rail (as shown).
Use the supplied screws to attach the DIN clips to
the IE-Giga-MiniMc, then snap the converter to the
DIN rail.
To remove the converter from the DIN rail, use a
flat-head screwdriver in the slot to gently pry the
converter from the rail.
NOTE
The DIN clips are designed for use on a DIN-35 rail.
NOTE
When using stranded wire, the leads must be tinned, and equivalent to a 16 AWG solid
conductor.
The IE-Giga-MiniMc is protected against mis-wiring; if mis-wired the IE-Giga-
MiniMc will not function. The IE-Giga-MiniMc is internally connected to the negative DC
power terminals.