User's Manual

13
Figure 15: A screen shot with the settings check box active.
Left Laser Start and Stop / Right Laser Start and Stop
These settings are the adjustments for the laser scanners on the left and right
sides of the DataGuard rf UHF Label Programmer. Moving the sliders under each
column will visibly change the beginning and end points of each laser scan line.
Adjust the scan lines by moving the sliders so that each line extends slightly
beyond the edges of its respective barcode label without interfering with the label
in the other column.
Left Scanner COM / Right Scanner COM
The communication or “COM” ports exist as virtual ports on the programmer. A
single USB cable links the programmer to the computer with the DataGuard rf
UHF software, and the selection of com ports is automatic. The user can
determine the communication ports for the laser scanners with these drop-down
options. The range is none to 15 for the left and right scanners.
Left RF COM port / Right RF COM port
The user can also determine the communication ports for the RF scanners with
these drop-down options. The range is none to 15 for the left and right scanners.
Left RF Power / Right RF Power